About keithsauer507

keithsauer507 · 01-09-2019

Well for our one site we have a 3750x switch stack ipbase on 12.2(55)SE12. I know I have to upgrade ...

keithsauer507 · 01-08-2019

We are using OSPF as our interior routing protocol with all default timers. I've tested failover bet...

keithsauer507 · 12-20-2018

Everything went smoothy. On the switch side, the ports were preconfigured with appropriate vlans and...

keithsauer507 · 12-18-2018

I have a Cisco 5508 WLC that currently has 4 copper RJ45 gigabit SFP modules plugged in and uplinked...

keithsauer507 · 12-17-2018

Perfect, thanks! Wiring up the fiber optic required performing a shut, no shut on that interface. Th...

keithsauer507 · 12-14-2018

Hello, I have a 2901 router with 4 active copper interfaces (two on board and two in two EHWIC-1GE-S...

keithsauer507 · 12-12-2018

I did not realize when you go to custom url categories and hit add new, you had a radio button for O...

keithsauer507 · 12-12-2018

Well Ken, I'm not sure if I can say this is resolved but so far the activation prompt came up on ano...

keithsauer507 · 12-10-2018

We have an S600v running 11.5.1-124. All of a sudden we've had some calls where Microsoft Office (wo...

keithsauer507 · 10-23-2018

I cleared all of that out of the config. Then it complained about line 14255 wbrs_command_manager_ca...

keithsauer507 · 10-23-2018

Then I delete this S600V from disk and download and install the S600V that is the same version numbe...

keithsauer507 · 10-23-2018

I'm trying to migrate our configuration from our current live S300V to a new virtual deployed S600V,...

keithsauer507 · 08-17-2018

We had a strange hiccup in internet connectivity but yet our endpoints did not log any downtime or i...

keithsauer507 · 08-17-2018

That's what I had to do. I didn't realize I could check back later. I never save those links, so luc...

keithsauer507 · 08-17-2018

The machines have valid ipv4 addresses. Its strange that with working ipv4 addresses from DHCP they ...

Date Registered	‎12-24-2009 08:25 AM
Date Last Visited	‎01-22-2021 12:09 AM
Total Messages Posted	614
Total Helpful Votes Received	55

Re: If I enable BFD, will my OSPF route go down until I complete BFD on remote end?