HiHi, we have vPC to router 1 and Router 2 via l3 port-channel on both cores. If i do a sh ip eigrp topology table I see only Nexus 2 (not Nexus 1) - is this normal?Nexus 1 - Nexus 2 \ vPC | / \ / ...
Hi
We have a Cisco 2821 and looking at the logs
043669: Jun 19 12:14:23.795 CEST: %ENVMON-4-FAN_LOW_RPM: Fan 2 service recommended043673: Jun 19 12:14:53.795 CEST: %ENVMON-4-FAN_LOW_RPM: Fan 2 service recommended043678: Jun 19 12:15:23.795 CEST...
Hello
Scenario - I have two ISP's terminating on Cisco Firewalls (Active/Passive) - is it possible to run BGP between the two ISP's and the pair of Cisco Firewall (failover mode) - I am not how the iBGP will work between them as they both share the...
Hello
I have a broadband connection and need to extend its coverage
Could I use a cisco access point to extend the coverage? (like a wireless repeater mode)? If yes can anyone send me the config please?
Thanks for all your replies we do have all these commands - please see our config belowI do see eigrp neighbour from both upstream routers however if I do a sh ip route to another vlan that is behind the core then I see only 1 routeCore 1vpc domain 1...
