About Antonio Knox

Antonio Knox · 10-16-2015

All,I've been combing through documentation for a direct answer to this, but can't find one.I have a 5.2 ACS appliance that I need to replace it with another appliance running ACS 5.7. From what I've found, you would need to be running 5.5 to upgrad...

Antonio Knox · 02-04-2015

Quick Question folks...I understand that in ASA 8.3 and higher ACLs do real ip addresses instead of NAT'ed addresses. My question is, if you still use NAT'ed addresses will it work?Thanks in advance...

Antonio Knox · 10-21-2014

Guys,I'm trying to find sample log output for Power Supply failure. My goal here is to write an EEM or ESM script to forward a log when a power supply failure is detected. This log will trigger an email notification by our syslog server to notify m...

Antonio Knox · 10-03-2014

All,I'm wondering if there exists a document that contains all of the system messages that exists for the 6500 (Sup 720 3BXL), much like there is a Syslog document available for all OS versions of ASA? I'm attempting to find sample output for power ...

Antonio Knox · 04-14-2014

I've been looking over this data sheet and I've stumbled into a bit of confusion....http://www.cisco.com/c/en/us/products/collateral/unified-communications/unified-survivable-remote-site-telephony/data_sheet_c78-520521.htmlAccording to this, E-911 su...

Antonio Knox · 08-22-2017

I would like to add a point of clarity here. What eng.omarka is calling wrong is correct in that you can't use an interface in two separate SPANs as he demonstrates. That's not what's being asked in the OP. The OP asks if there can be multiple des...

Antonio Knox · 11-14-2016

BPDU guard is a portfast feature that protects your spanning tree on edge ports (Access ports). It (in layman's terms) monitors your port for BPDUs. If it see's one (presumably from an unauthorized switch, hub or host), it shuts the port down (err-...

Antonio Knox · 06-01-2016

FYI, I ran into this same issue and was able to resolve it by shutting down the port on the Nexus side, reseating the FET module and fiber connectors on both ends, then turning the port back up. It's not a sexy solution, but it did the trick for me, ...

Antonio Knox · 10-16-2015

This solution worked out great! Thanks again.

Antonio Knox · 10-16-2015

ivangonz,Thank you for your reply. I'll try this and see how it goes.

Member Since	‎02-02-2006 09:12 AM
Date Last Visited	‎04-05-2024 12:24 AM
Posts	582
Total Helpful Votes Received	346

User Statistics

User Activity

ACS 5.2 Backup Restore on ACS 5.7

ASA 8.3+ ACLs

Syslogs for Power Supply Failure

System Logging Reference

SRST 7.11 & E-911

Re: this is wrong info u can Only

Re: BPDU Guard explained please

FYI, I ran into this same

This solution worked out

ivangonz,Thank you for your