tkavithas87
Level 1
Level 1
Member since ‎05-21-2012
‎10-09-2017

User Statistics

  • 179 Posts
  • 0 Solutions
  • 180 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
1 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

Hi all,i have an issue with the CME GUI.normally when we add new phones to the network the phone will appear on the GUI.but one of the phone is not appearing.but this phone is registered.can able to configure using CLI.what could be the cause?thanksk...
Hi all,i have an issue with the CME GUI.normally when we add new phones to the network the phone will appear on the GUI.but one of the phone is not appearing.but this phone is registered.can able to configure using CLI.what could be the cause?thanksk...
   HI all,one of the cutomer contact center is running in uccx 7.0(1). the Agents are using CAD to answer the calls.this cutomer wants ,after the conversation with the caller,when the agent press "end call button" on the CAD,it should  redirect to a ...
How many  IP phones does UC560 support?Datasheet indicating 138.but addition of  max-ephones under telephony service , max pool under voice register global are more than 138.
I slotted the vic2-fxo card into the ISR 2911.but in the running config there is no port available.when issueing the cmd show inventory,the fxo card is available.what other configuration should be done to enable this voice-port?.note that there is no...
Community Statistics
Member Since ‎05-21-2012 02:09 AM
Date Last Visited ‎10-09-2017 12:48 PM
Posts 179
Total Helpful Votes Received 5
Helpful Votes From
Helpful Votes Given To