Hi all,
First of all, apologies if I picked the wrong section.
What I am wondering if the following is possible, if so do we have any guides?
I need to configure voicemail (Unity) on an analogue telephone that's being looped through a Cisco ATA...
Hi all,
We are trying to create a user experience that is easy for our customers which basically they connect to our wifi and once connected they simply only have to hit 'logon', 'connect' or something of that nature.
Is this possible with ISE? We ...
Hey,
I'm just wondering if someone could help - I was trying to create a repositary for my ISE backup which is on an SFTP server but ISE sent a pop up to my screen stating:
'Host key of sftp server must be added through CLI using 'crypto host_key a...
Hi, I was just wondering if you could help - I am going to be deploying 802.1x to roughly 2000 endpoints that have Cisco handsets attached to them. I have the configuration that I would want to put on the network device to query ISE and the 802.1x po...
Guys, I've built a lab in gns3, one router and one ASA, the ASA has an inside, DMZ (with a small network behind it with just 1 server up and running at present) and an outside interface whilst the router has 3 interfaces on 3 subnets that connect a P...
We are also receiving this issue on between ISE 1.3 patch 4 and our WLC's that are on 7.1. Can anyone suggest what version of WLC you have that is not displaying the error message on ISE?
Cheers
Here is an update, I'm still confused to what I could be doing wrong:I am chucking everything from the router over to the ASA with the static route belowR1#sh run | in ip routeip route 0.0.0.0 0.0.0.0 192.168.100.1 Below is the interfaces on the ASA....
Thanks for the reply Mike, I had put static routes from R1 pointing to the ASA and to the correct subnet...I will update the config later, but I am getting deny messages from the ASA basically saying it cannot see the route, as if it's trying to go o...
Thanks for the quick response. Yes, I feared that would be the case as you cannot just dynamically upgrade the fs quota.We were planning a rebuild of the pub due to a vCPU that we hoped to deploy.Thanks
Hi Rick,I should really point out that I just copy and pasted the current config - I have tried it as plain access, trunk and other configs, simple access without any port channels and trunks but nothing seems to work. I am going to pick up the older...
.png "Mike Williams"){kind=avatar}
