About kent.plummer

kent.plummer · 07-09-2013

Hi, Hopefully someone has seen this one before. I have several 887G routers connecting to the Telstra 3G network and into a private IP VPN. These all work fine however overnight the 3G interface times out (I assume) and requires a shut / no shut to...

kent.plummer · 05-18-2012

I have not yet caught up to speed on ASA 8.3 changes and came across the below working ACL on an ASA running 8.3. The ACL is applied inbound to an Internet facing publicly addressed interface. At this point the destination IP in the packet will not...

kent.plummer · 08-30-2011

Hi all,I have an issue with using the OSPF downward bit and hope someone has seen this before. It appears to do nothing in this example to prevent routes being learnt via the wrong path. That is via a backup router that has learnt the route from th...

kent.plummer · 06-25-2010

Hi all,Wondering if anyone has successfully used "neighbour next-hop-unchanged"?I'm attempting to use the BGP "neighbour next-hop-unchanged" but Im still seeing a change in the next hop IP address. I have this specified on the bgp peer facing CE1.Th...

kent.plummer · 12-18-2009

Hi,Does anyone know what my wireless headset options are for the SPA 500 series ie 502G, 504G, 525G phones? http://www.cisco.com/en/US/products/ps10499/index.htmlI cant see any mention of electronic hook switch support.The 525 has bluetooth support....

kent.plummer · 07-25-2013

I just caught a router in this state with the 3G interface not responding.The cellular interface is UP and an IP address is still bound to dialer2 yet it wont pass any traffic.If I shut, then no shut the cellular interface it will then function corre...

kent.plummer · 05-18-2012

A pretty good move. Im not so sure about the object based NAT setup but Im sure I'll get used to it.Thanks for the tip.

kent.plummer · 03-17-2012

I have just encountered a similar situation. It seems to work near enough, but I still consider it a hack. Also if the second peer (887 router in this case) attempts to bring up the IPSec tunnel the ASA drops the the primary tunnel and restablishe...

kent.plummer · 08-31-2011

Yes that does sound viable Peter. I'll sleep on it and discuss with the team. Thanks for the advice.I also read that not using area 0 for the PE-CE links changes things but its not clear if this will help at all as all the CPE will still be in the ...

kent.plummer · 08-30-2011

Hi Peter,Hopefully the attached helps a little. The classic sham link scenario does not really apply here. Both routers are in each case at the same site and are directly connected to each other and the local site /24 subnet. Its a active / backup ...

Member Since	‎11-04-2001 06:32 PM
Date Last Visited	‎10-09-2017 01:02 PM
Posts	47

User Statistics

User Activity

887G 3G wireless timeout

ACL: Use of private inside IPs in the Internet facing ACL

OSPF downward bit in MPLS network

neighbor next-hop-unchanged

SPA5xx phones - Wireless Headsets

887G 3G wireless timeout

ACL: Use of private inside IPs in the Internet facing ACL

question about site to site VPN failover on an ASA

OSPF downward bit in MPLS network

OSPF downward bit in MPLS network