About ken.montgomery

ken.montgomery · 12-18-2012

I have searched and read about bulk-loading speed dials, also about the fast dial command, and I'm s...

ken.montgomery · 11-14-2012

Found that the port was not fully up yet. Once the port was up the vlan came up. Now to figure out w...

ken.montgomery · 11-14-2012

Ok, am testing this now. Logged into switch, insured the int VLAN xx is not shutdown. Next chose an ...

ken.montgomery · 11-14-2012

Hi All, have done this many times before, but for some reason either I'm missing a step or something...

ken.montgomery · 08-23-2012

Hi Everyone, we had mis-typed the service provider name in our CME, and we could not make calls. I h...

ken.montgomery · 08-20-2012

Chris, we were able to work through Cisco TAC and come to a resolution. It appeared the INVITE part ...

ken.montgomery · 08-17-2012

I don't figure, or else I wouldn't be hanging around asking how to do this mess So, I added the inco...

ken.montgomery · 08-17-2012

I have not tried using a dialplan-pattern, and I don't see a correct format for that command in any ...

ken.montgomery · 08-17-2012

Hi Cisco Community!I am new to inbound/outbound SIP being used with the CME on a 2951 router. I've m...

ken.montgomery · 08-13-2012

Thank you for the quick response... I'm also hopeful someone will post their experience with Skype a...

ken.montgomery · 08-13-2012

Hi Everyone, I have a project that came at me quickly, and am looking to confirm what I've found onl...

ken.montgomery · 08-06-2012

Just a quick question... not being a QOS guru or anything, am looking at one of our sites setup by s...

Date Registered	‎08-06-2012 06:23 AM
Date Last Visited	‎08-18-2017 04:03 AM
Total Messages Posted	118
Total Helpful Votes Received	10

Speed Dial CME with 6911 Phones