NormMuelleman

Follow-up to this issue:We found out a couple things during troubleshooting. If you put a loopback o...

Unfortunatly, I can't copy/paste as this is on another network.And, the wire guys went out and did s...

I concur, use etherchannel to provide redundancy and load-balancing. IT isn't a 9-5 job Sounds like ...

1. Since the switch was hard-rebooted, I dont have any results for the sh interface status err. The ...

I was curious to see if there were any updates to this issue. I am wondering if further testing was ...

Here in my office, we are all scratching our heads on this one. Switch A Switch BPo1 Po1G1/0/1 G1/0/...

I'm posting this here as well at Network Management;Hello allHaving an issue with NTP at my new loca...

Hello allHaving an issue with NTP at my new location. Bit of background:Access A Access B Distro Cor...

So, if I get this right, CUCM 8.x does not support what we are trying to do. What about setting up a...

Greetings; We are using CUCM 8.x. We have 4-6 phones that need to be in a party-line type scenario. ...

I am probably waaay over thinking this issue. That, or it being 3:15 am could be the problem We run ...

Restrict vs shutdown...which is the preferred method of port-security? I have argued that shutdown i...

Can you post the ip route output? Where are the routes not propogating to? Is it on the 3750 or the ...

This may be off-topic for you Charlie, but it's just a thought...Last week I had noticed our NTP had...