I want to use C1111-4P as terminal server for other router's console port.
I found past discussion in below, and I tried to make it, but not successful. (attached is current config)
https://community.cisco.com/t5/other-network-architecture-subjects/i...
C1111-4P has only one serial port (con 0)
I tried to use the port for accessing console of another router, but telnet is rejected.
#telnet 10.10.10.10 2000Trying 10.10.10.10, 2000 ...% Connection refused by remote host
10.10.10.10 is loopback of C111...
I am firstly setting up C9800 , but AP join is not working and stays in "ap auth pending".DTLS session is established by checking "Monitoring -> Wireless AP statistics -> Join statistics".I tried adding AP mac address in "Tags-> AP -> Static" , but i...
I configured ISATAP between two routers.[Server cisco3845 ver 15.1(4)M12a]interface Tunnel4 no ip address no ip redirects ipv6 address 2001:22:33::/64 eui-64 ipv6 enable ipv6 nd cache expire 10 no ipv6 nd ra suppress tunnel source Loopback0 tunnel mo...
After enabling "debug telnet", I can see debug log when I make normal telnet (port 23), but cannot see any log by telnet with port 2000 or 2001.
I guess telnet process on router is not listening incoming connection with port other than 23
Port 2001 does not work either.
Router#telnet 10.10.10.10 2001Trying 10.10.10.10, 2001 ...% Connection refused by remote host
I think 2001 is allocated to TTY 1, but it is VTY 0, not serial like AUX 0
There is no logging while making connection tests...
Hello BB,
unfortunately, it did not work here.
Following is "show line", config of line and result of telnet. 10.10.10.10 is loopback IP address.
Router#sh lineTty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int0 CTY - inout - - - 0 1 0/0 -...
