Hello,
I noticed a weird issue with REM's video. When we use standard H264 codec, there are lot's of output queue drops on access switches, to wchich a jabber client is connected. The number of drops is enormous, and the video quality is very poor. S...
I face a weird issue with Prime Infrastructure 2.2. We have few ASA 5545-X clusters (active/active), and I am unable to add them to monitoring. Regardless of which IP address I use, VIP or physical, Prime cannot properly log into ASA with SSH. I get ...
Hi,Is there any (hidden) command to check per-queue statistics on Nexus 3048T? Something like "show policy-map interface" on Cisco routers. This command run on N3K shows only configuration. How can I verify how much traffic is passed or dropped in sp...
Hello,According to datasheets of ASR1001X and ISR3945-E maximum supported IPSec tunnels (site-to-ste) is 4000. Real-life example which we face shows, that ASR has a problem with 1500 tunnels (memory leaks, reboots, tunnel hangs, etc, the most recent ...
Hello, I am just wondering, how much impact on the network/devices (for example 3945E with 80Mb WAN link) would have a specific QoS configuration, where I have a branch with contact center agents, and the amount of voice traffic reaches over 60% of e...
Hi, I have ssen this command. I was rather thinging about something more detailed (even with WRED per DSCP). I have checked all commands which available, and no such thing :-( may some hidden command?Cheers,Krzysztof
I saw on that presentation that VPC is supported only to end hosts through single-homed FEXes. I cannot find it anywhere, but is direct VPC supported to end hosts without using FEX? For example, can I attach Fabric Interconnect to two 9396PQs using V...
Hello,I just wanter to refresh this issue. I understand the reason of dispute on a certain link, but recently I had a situation where dispute appeared on all links attached to N7K. There are two reasons I can think of. One is some kind of bug/instabi...
