Ok. The disconnect cause is 47 = resource unavailable which normally is a codec negociation issue. It looks like your prefer codec coming from Polycom is G.729 and you prefer codec to CUCM is G.711. When you call from Polycom to CME phone what codec ...
Hi Haveen, Looks like CUCM is loosing communications with the phone but this trace only has a smal piece of it, I see where the CUCM send a ring request to the phone but the next event is the phone changing status to clear.Do you have a trace level...
What Access Point are you using? Do you have voice and data VLAN in your wireless network? and have you done any QoS configuration at the AP level?- Luis A.
Just for your reference:Loss of frame alignment (LFA)LFA condition also called out-of-frame (OOF) Loss of multi-frame alignment (LFMA)Loss of signal (LOS)Alarm indication signal (AIS)Remote alarm indication (RAI)CMQ_EVENT_E1_FRMR_RAI_ALARM The RAI al...
Try using the following commands:Service phone daysDisplayNotActive Service phone displayIdleTimeoutService phone displayOnDurationService phone displayOnTimeHere is also a previous answer from Rob.https://supportforums.cisco.com/thread/2080523-Luis ...
