Make sure that Cisco Discovery Protocol (CDP) is enabled globally on the switch (cdp run) and on eac...

Have you got a bug ID on this? I did not have the same symptons as the original post. My session jus...

I was able to fix the problem. Looks like there were L3 roams happening because the 'User Idle Timeo...

I'm not sure why it was set so high, but I've changed it down to 30 mins and will decrease it furthe...

Would you recommend separate mobility groups for controllers on each campus (2 per group), given the...

That's the thing. We are not anchoring and there are at least 2 miles between campuses.

All APs are connected to their "proper" primary controller.

I just re-created your scenario and was only able to make it work by blowing away the config and bui...

Port channels need to have matching native VLANs and allowed VLANs on both sides or you'll end up wi...

I would add 'switchport trunk allowed vlan 5,300-302,500,600-602,700,701,805,900-902' on po1 on the ...

Alternating green/amber is indicative of a link fault:http://www.cisco.com/en/US/docs/switches/lan/c...