So include that VLAN on your trunks:! lab1int fa0/1 switchport trunk allowed vlan add 100!! sw-testl...

You could just wipe and erase the 2950 and plug it in as it is. That would be 'wr erase' and 'delete...

There is your Native VLAN mismatch. Port fa0/1 is sending VLAN 808 and gi 4/0/20 is sending 104. Wha...

Can you give a 'show run int fa0/1' on lab1 and 'show run int gi4/0/20' on sw-testlab.dgit.net? It l...

That's my PC. That's the confusing part of this whole thing. I can get an address, but my APs cannot...

DHCP is off on a different VRF so we have 2 ip helper-address on the L3 interface for primary and se...

The DHCP request look like any (src: 0.0.0.0, dst: 255.255.255.255) other except for the fact that t...

Hi all, We just ran in to an issue with a particular building unable to restore wireless connectivit...

If you are running PVST/PVST+, your limitation will likely be the maximum number to spanning-tree in...

Can you post the configuration for po22, gi3/0/4, gi4/0/4 and the corresponding ports on the other s...

Why not use the .tar file and the archive command?archive download-sw /overwrite /force-reload tftp:...

'Fast SSID change' is set on the 'Controller' tab. 'Fast Transition' is to enable or disable a fast ...

Thanks for the response. While I've got you on the subject, can you confirm that this is how we disa...