Hi Cisco Community,
We do have some Cisco APs under a Cisco WLC 5520 that needs 2.4Ghz radio be disabled and some Cisco APs need to have their transmit powers adjusted. But it seems I am not able to do that. When I go to the command line of the APs,...
Hi,
I hope you are all doing great.
On our MPLS Circuit, outgoing EF traffic should be limited to 1Mbps. But our EF traffic requires more than that. Now upper management don't want to increase EF traffic (as it has extra cost).
I'm thinking of dro...
Hi,
Is it normal for certain applications to mark packets ? I don't have inbound markings yet on my Cisco router yet there are hits for cs6, cs7, af31, af21 and all.
Hi Everyone, What could you suggest when we always have a PIM neighbor always going down ? Router has no issues, but the ISP is. Kindly advise. Thanks! Sep 21 23:56:06.176: %PIM-5-NBRCHG: neighbor <IP> DOWN on interface GigabitEthernet0/0 non DRSep 2...
How do you configure ssh on Cisco 4507 ? I did "show ip ssh" and the log below is displayed as a result.Router#show ip sshSSH Disabled - version 1.99%Please create RSA keys to enable SSH (and of atleast 768 bits for SSH v2).Authentication timeout: 12...
Thanks Joseph, but I saw AF31, AF33 as well. I have attached QoS related configurations on a switch directly connected to the router. I'm not a QoS expert, but can you kindly check if the configurations might be the one marking the packets towards th...
@mheusinger .. first of all, thanks for that reply. i'm looking a debug command that can show this. is there any ?how would we be able to know if the invalid timer already started ? hold down timer ? flush timer ?
