Leo Laohoo

Leo Laohoo · 05-12-2009

"You can only use privileged-mode commands with kron; it doesn't allow any Global or Interface confi...

Leo Laohoo · 05-12-2009

Hi Zubedi, I don't think XFP could be supported in 3750-E, however, SFP+ is about to be released. ht...

Leo Laohoo · 05-12-2009

Two things pop into my mind with your output. 1. Check the two power cables to PS1. It's either the ...

Leo Laohoo · 05-12-2009

G933.2 is ADSL1 while G933.3 is ADSL2. ADSL2 is backward compatible to ADSL1.You can start with HWIC...

Leo Laohoo · 05-12-2009

The Precision Time Protocol (PTP), as defined in the IEEE 1588 standard, synchronizes with nanosecon...

Leo Laohoo · 05-12-2009

The only difference, in my opinion, is the power cord for both the ISR's and Power Cube's. Another t...

Leo Laohoo · 05-11-2009

Hi Scott, Cisco is about to release the Autonomous IOS (aIOS) for the 1140 soon. However, Cisco SE c...

Leo Laohoo · 05-11-2009

Depends on the IOS ... You can use a variety of commands on the interface-level.power inline consump...

Leo Laohoo · 05-11-2009

Hi Fernando, I think it's because of the FCC Compliance code. The "A" or "N" means that your model, ...

Leo Laohoo · 05-11-2009

Errrr ... does this have anything to do with your wireless?

Leo Laohoo · 05-11-2009

Firstly, you need Single-Mode fibre. Do you need a media converter? Depends on your router. If you d...

Leo Laohoo · 05-11-2009

Did you try putting "ip helper address" on the SVI?

Leo Laohoo · 05-11-2009

If you are going to have only ONE IOS, then you don't need to because the switch is smart enough to ...

Leo Laohoo · 05-10-2009

Q: Can I use existing gig ports to acheive stacking?A: Sure you can. Fiber and/or copper can be achi...

Leo Laohoo · 05-10-2009

Hi Saeed, When you upgrade the license from Standard to Enhanced, your switch should respond with an...

Date Registered	‎06-22-2008 04:57 PM
Date Last Visited
Total Messages Posted	51,084
Total Helpful Votes Received	31391

Re: Cron Job on Cisco IOS Router?