Leo L

Leo L · 05-23-2022

Means the Rx (receive) of the optics is too "faint". Check the patch cable, the fibre path and, fina...

Leo L · 05-23-2022

@lowfell wrote: Also, if No password recovery was entered in to original config, how can we restore ...

Leo L · 05-23-2022

What firmware is the WLC on?

Leo L · 05-23-2022

Post the complete output to the following commands: sh version sh boot dir flash-1: dir flash-2: sh ...

Leo L · 05-23-2022

Post the complete output to the following commands: sh platform resource sh platform software status...

Leo L · 05-23-2022

@caleb1 wrote: They are running version 16.3 16.3 what? I want to see the entire version number.

Leo L · 05-23-2022

Contact Cisco TAC and organize for an RMA. The micro-code is corrupt.

Leo L · 05-23-2022

@Asfandyar70754 wrote: So both SFPs will support switches 9407 and 2960 right? 2960 will not support...

Leo L · 05-23-2022

GLC-TE is copper cable (Extreme condition), 1Gbps GLC-SX-MM is 1 Gbps, multi-mode

Leo L · 05-22-2022

Console into the AP and reboot the AP. Post the complete boot-up process.

Leo L · 05-22-2022

Maybe the school IT provider is trying to "on-sell" you more (expensive) solution like a wall-mounti...

Leo L · 05-21-2022

@enajin wrote: does Cisco not have a 10G LC mm SFP that that can also be adjusted to handle 1Gb/100M...

Leo L · 05-21-2022

Switches do not support "untar" commands. Look for the BIN file push that through. Once the switch b...

Leo L · 05-21-2022

@bluesea2010 wrote: If we order 9600 chassis two line card will be included without additional cost ...

Leo L · 05-21-2022

Have a listen to the mov file (attached). This is a recording of a phone conversation between a phon...

Date Registered	‎06-22-2008 04:57 PM
Date Last Visited
Total Messages Posted	51,047
Total Helpful Votes Received	31321

Re: ASR1001-HX