FN - 72520 - Some Cisco DNA Center Appliances Shipped Between September 2022 and November 2022 Have Incorrect Firmware Installed - BIOS/Firmware Upgrade Recommended
Cisco 3850: IOS-XE/Firmware Upgrade
(Install Mode)
NOTE:
This procedure is aimed at Cisco 3850 switch ONLY.IOS-XE Bundle Mode is not covered. 9300, 9500 (vanilla & high-performance), ISR 1k, ISR 4k and ASR is not covered. Router(s) & switch(es) r...
NotesA Word from our Sponsors:Introduction:Section 1: General ProcedureSection 2: ROMMON UpgradeSection 3: Cellular Modem Firmware UpgradeSection 4: GOTCHA
Notes
This procedure is aimed at Cisco ISR 1k, ISR 4k and ASR 1k router ONLY.IOS-XE Bundle Mo...
As far as I am aware, this is not possible. The logic is absolutely "wild". Think about it. Anyone can assign ports to any VLAN but no one can change the port VLAN assignment if said port is already in VLAN 92.
The issue is not the implementation. ...
We have an EEM script that changes the description of the interfaces. The EEM script determines if the device is a Cisco AP. If it is an AP, it changes the description of the interface. If it is not an AP, it leaves the description alone.
For Realtek RTL88xx, the wireless NIC driver should be, at a minimum, 6001.10.352.0 (and later). Refer to CSCwf03870.
For Intel-based AX2xx, the wireless NIC drivers should be 22.200.2.1 (and later) or 22.220.0.0 (and later). Refer to CSCwe50033.