Since the last firmware upgrade of the RV180w I seem to have lost the option to use jumbo frames. I used to have 4k frames on my NAS and 9K on my workstation which worked fine and increased the throughput, after the latest firmware upgrade I get dropped connections or no connection at all. All cabling is Cat6a and speed is 1G so that should be a problem. Does the build in switch stop jumbo frames from being transmitted?
... View more
I just posted something similar. Is this behaviour by design? It actually are not only the mentioned addresses also the traffic between router and workstation are reported. as well as my Mediaserver and router. but also traffic between WAN and my Mediaserver.
... View more
On the latest firmware I receive quite a number of NO CONNTRACK FOUND [DROP] kernel errors, about 5 every second. What is the cause of these errors and are they harmful or indicate a configuration error What can I do to prevent these errors from occurring?
... View more
No the other way around. The NE connected to the wlan on the RV180 are blocked from Internet, The ones from the other AP had access. And the RV180w know about the other AP by way of "rogue AP" settings, right?
... View more
Thanks! I seriously started to doubt my brain. I can live with the one AP for the time being but had I known this I would have got the RV180..
... View more
As the WLAN is not working properly on the RV180w we have disabled WLAN. On the Dashboard it is reported as active with 1 users. This is not correct. Please update the fireware. Thanks!
... View more
Thanks for your questions The RV180w is on the latest firmware. For other reasones I have flashed the device new but the CPU is reported as 100% there is virtually no traffic. Two of the ports is connected to a switches which handles LAN traffic. Also an external DHCP and DNS server is deployed. So the only thing that is active on the RV180 is the firewall and the bridging von WAN to LAN.
... View more
Traffic from my WLAN is not routed to WAN. I can access LAN and connect to all NE on the LAN. But access to internet is not possible. Access from LAN to WAN is allowed. I've reset the RV180w to factory settings and also reflashed the firmware to make sure. Is it required to configure a static route from wlan to wan? The routing table the the RV180 generated Destination Gateway Genmask Metric Ref Use Interface Type Flags 127.0.0.1 127.0.0.1 255.255.255.255 1 0 0 lo Static UP,Gateway,Host 172.16.0.0 0.0.0.0 255.255.254.0 0 0 0 bdg1 Dynamic UP 85.0.84.0 0.0.0.0 255.255.252.0 0 0 0 eth1 Dynamic UP 127.0.0.0 0.0.0.0 255.0.0.0 0 0 0 lo Dynamic UP 0.0.0.0 85.0.84.1 0.0.0.0 0 0 0 eth1 Dynamic UP,Gateway
... View more