Cisco Community
English
Register
Great changes are coming to Cisco Community in July. LEARN MORE
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Ronit Bhattacharjee
‎12-06-2020

Beginner
Recent Badges
Awards
Recent Badges
See all
1 Accepted Solution
30 Helpful Vote
10 Helpful Vote
1 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies
Stats
Member since ‎11-26-2009
65
Posts
83
Helpful
4
Solutions

i have some question about EBGP in same broadcast ??

Created by in Routing
11-01-2011
11-01-2011
The outputs you sent are not consistent with the diagram you showed earlier. Disregarding the diagra...

i have some question about EBGP in same broadcast ??

Created by in Routing
11-01-2011
11-01-2011
Hi,Attach "show run", "show ip bgp summary" and "show ip bgp" from all 3 routers.

Re: PRI backplane clock source

Created by in Routing
10-10-2011
10-10-2011
Hi Murali, It might. I am not sure. I would recommend that you try this after-hours or during a brea...

Re: PRI backplane clock source

Created by in Routing
10-10-2011
10-10-2011
Hi Murali, The only thing the provider needs to do is make sure both lines have synchronized clockin...

Re: PRI backplane clock source

Created by in Routing
10-10-2011
10-10-2011
PRI controllers need to derive the clock from the backplane so that the E1 is synced to the PVDMs. U...

Conditionally shutting down an interface

Created by in Routing
08-29-2011
08-29-2011
This is a bad design. As cadet already said, just use the same subnet on the LAN interface of both r...

Re: Nat every port on a public IP to particular port on private

Created by in Routing
06-02-2010
06-02-2010
Calin already gave you a resolutionip nat inside source static tcp 10.1.1.1 8888 1.1.1.1 1 extendabl...

Re: IOS upgradation steps in ASR 1006 with redundant RP

Created by in Routing
04-06-2010
04-06-2010
Follow this steps without an exception and you'll be finehttp://www.cisco.com/en/US/docs/routers/asr...

Re: Router over-advertised network prefix

Created by in Routing
03-31-2010
03-31-2010
High number of prefixes caused BGP to go down? If the ISp has a limit on their end they would probab...

Re: Basic question on route not in BGP routing table

Created by in Routing
03-31-2010
03-31-2010
Hmm.. Very fishy.. you;ve mentioned 330 everythwre in the show commands.. Which means you have not c...

Re: Error message at Catayst 3560, somebody knows this error?

Created by in Routing
03-31-2010
03-31-2010
Tracebacks point to bug CSCsv11710, fixed in 12.2(50)SE1 and above.Could also be a hardware issue bu...

Re: Cisco 887 No ATM Interface

Created by in Routing
03-31-2010
03-31-2010
887 should have atm interfaces. The output you see looks similar to what you would see on an 886. Ma...

Re: how to configure 3 VWIC2-1 MFT E1 card

Created by in Routing
03-31-2010
03-31-2010
This is a simple config. Just remove all layer 3 config from the serial interfaces and do thisinterf...

Re: 3825,System returned to ROM by bus error HELP!!!!

Created by in Routing
03-31-2010
03-31-2010
The router must have spawned a crashinfo file when it rebooted. If you can get me that, I can try lo...

Re: Cisco 2500 and crypto

Created by in Routing
03-31-2010
03-31-2010
There were k9 images for the 2500 till 12.2 but they are now all deferred and not available forpubli...
Public Statistics
Date Registered ‎11-26-2009 08:14 AM
Date Last Visited ‎12-06-2020 08:22 AM
Total Messages Posted 65
Total Helpful Votes Received 83
Helpful Votes From