We have a situation as the attached image.Forward flow : Traffic comes in on Port 1 and leaves Port 3Reverse flow : Traffic comes in on Port 3 and leaves Port 2 As you see, there's asymmetry here and the ASA is dropping this flow. Is there a way to o...

All,I can successfully reload all my Cisco 3650/2960 switches using SNMP, but I cannot use the same method with the ASR920 snmpset -c rwcomm -v 2c x.x.x.x .1.3.6.1.4.1.9.2.9.9.0 i 2 On the ASR920, I get a "Reason: notWritable (That object does not su...

Team,   My router has a hostname and ip-domain configured. If I use the following command manually on the router in config mode, I am able to generate the crypto key and enable SSH.   crypto key generate rsa modulus 4096   However, if I load a new st...

I have fully functioning Layer 2 MPLS running over my network on Cisco ASR 920 routers. One of the links between 2 routers is provided via a 3rd party service provider, though, which requires us to use encryption on this link to protect our data.   I...

Hi, I have VPLS between 2 ASR920 routers running fine, can ping across the same Vlan from one Laptop to another.   When I turn off VPLS on the physical interface, instead bring up a GRE tunnel and configure VPLS on the GRE tunnel, I am unable to ping...