About David Kos

David Kos · 10-17-2019

Hi Cisco TAC Team,I have a client with 2 SX80's in different rooms that are displaying an Audio Delay error in the WebEx hub. The display is made by Samsung and the client shows the displays as having gaming mode On and no other video processing type...

David Kos · 10-08-2019

Hi Folks, I have a client that has a Cisco SX10 that is using a Cisco mic with 1 extension cable. They need to extend the mic even further into the room, can a second Cisco mic extension kit be added to extend the length? If yes, are there any limi...

David Kos · 09-20-2019

Hi Cisco,I have a client that had another integrator try and install a Room Kit Plus where the room kit codec was located under their conference table with the camera/soundbar located above their 86" Samsung monitor. They are having an issue with th...

David Kos · 02-01-2019

Hi Folks, I have a client that has a Cisco Room Kit Plus that is using a Precision 60 camera and wants to setup the Presenter Track feature. They have setup the Presenter Track feature in the past on other systems and they are familiar with the proc...

David Kos · 10-30-2018

Hi Folks, I have a client with an SX80 that is not outputting internal audio, like a rintone but far end audio during a call works just fine. Have you ever seen this issue? Is the system's internal generated sounds handled differently that say th...

David Kos · 07-12-2019

Thanks Wayne. The camera ended up getting replaced and all is good now at the client's site. Thanks for following up. DK

David Kos · 10-30-2018

Hi George,The calls come in and you get the audio from the far end site but you don't hear the call ring into the room.I also found out that Cisco's CE Terminal program was used to route some audio signals within the SX80. I'm wondering if once CE i...

David Kos · 10-30-2018

Hi George,The ringer volume on the endpoint has been verified to be On and turned up but still no audio when you change the ringer styles.

David Kos · 10-30-2018

Hi George,>From what my QA Engineer told me in the field, the room is registered to CUCM but it is managed overseas. Is there a setting or area that we need to make them aware of that can be adjusted in CUCM?

David Kos · 02-28-2018

The client's network team adjusted their network and blamed the VCS Control but they were 100% wrong! Thanks for everyone's replies, I'm accepting your solution to close.

Member Since	‎09-25-2013 01:50 PM
Date Last Visited	‎10-24-2019 11:03 AM
Posts	78

User Statistics

User Activity

SX80 shows audio delay issue at the WebEx Teams Portal

Cisco Mic Extension question?

ARC Issue using Room Kit Plus and non-Cisco HDMI cables or HDMI to Cat 6 adapters

Cisco Room Kit Plus with Precision 60 does not allow for Presenter Track Setup?

SX80 is not outputting internal audio, like a rintone but audio during a call works fine.

Re: Cisco Room Kit Plus with Precision 60 does not allow for Presenter Track Setup?

Re: SX80 is not outputting internal audio, like a ringtone but audio during a call works fine.

Re: SX80 is not outputting internal audio, like a ringtone but audio during a call works fine.

Re: SX80 is not outputting internal audio, like a ringtone but audio during a call works fine.

Re: VCS Control- rejecting IP address