About mnagired

mnagired · 08-08-2023

Cisco Public Cisco SD-Access for Manufacturing Vertical Contents AuthorsExecutive SummaryOperational Technology (OT)Industrial Automation and Control RequirementsSecurityNetwork Resiliency and UptimeEnvironmentalConnectivityUpgradeabilityRe...

mnagired · 12-30-2022

Hi Unlike appliance types are fully supported as Author and Reader nodes. No such restrictions on Cisco ISE. But point to consider, once you have a mix of different appliance types the number of Virtual network across author and reader will fall to ...

mnagired · 10-12-2020

Not really... The device will continue to stay in a Managed state... If Syslogs or traps are enabled to DNAC, then the moment there is a config change, the device will initiate resync or admin can manually resync from the inventory page.

mnagired · 10-09-2020

Hi,Firstly, Per VRF ibgp neighborship between the two borders is required only if your northbound connections arent full mesh.If your borders are C9K switches, then a Layer 2 Port-channel(trunk) with Per VRF iBGP running on SVI would suffice... Reg...

mnagired · 10-08-2020

Yes.. We recommend all configuration through DNAC.. Please use Template editor for any non fabric configurations.

mnagired · 10-08-2020

It’s Manual configuration.. No automation between two borders..

Member Since	‎10-06-2017 04:27 PM
Date Last Visited	‎09-27-2023 12:02 AM
Posts	74
Total Helpful Votes Received	80

User Statistics

User Activity

Cisco SD-Access for Manufacturing Vertical

Re: Network Architect

Re: Cli and dnac

Re: Border nodes link

Re: Cli and dnac

Re: Border nodes link