fdharmawan
Level 4
Level 4
Member since ‎10-08-2017
‎03-27-2024

User Statistics

  • 349 Posts
  • 9 Solutions
  • 387 Helpful votes Given
  • 107 Helpful votes Received
Recent Badges
100 Helpful Vote
 30 Helpful Vote
5 Accepted Solution
10 Helpful Vote
50 Replies
1 Accepted Solution
20 Replies
10 Replies
1 Helpful Vote
5 Replies
Certifications

User Activity

Hi Guys,I want to enable client threshold traps, so if exceeds a certain amount of client that is being handled by the AP, PI will send an alert stating that the AP might be overload. On the WLC, I found the setting on RF profile, but could not find ...
Hi Guys,Currently I am doing a wireless review. Some of the aspects being reviewed are AP tx power and clients connected to the AP on each radio. I am able to get the tx power on each radio by issuing "show advanced 802.11a/b txpower" command. But I ...
Hi Guys,Suddenly the netflow on my 3650 switch is not working. I have compared the config from the one back in 2021, it's the same, nothing was changed. But when I compare to the other switch which netflow is working, I realized that the current entr...
Hi Guys,I just found out that this morning I cannot login to the CUCM PUB and SUB using administrator account via web GUI. It was accessible yesterday using the same credentials. The error said "Log on failed - Invalid User ID or Password". But using...
Hi Guys,Is there any chance to check and change the threshold of alert on Cisco Prime Infrastructure? I want to check the current threshold for "AP Client Count Threshold Violated" and "AP Client Throughput Threshold Violated" alerts and might adjust...
Community Statistics
Member Since ‎10-08-2017 07:59 PM
Date Last Visited ‎03-27-2024 12:16 AM
Posts 349
Total Helpful Votes Received 107