Hey!the manual method has several drawback * it involves a lot of manual efforts and time to configure each of the devices. * it can lead to inconsistency in the configuration due to human errors when deploying the config.* configuration updates and ...

Ideally the most common issue you face during a brownfield device on boarding is the preexisting config on the device. You need to ensure that the device is clean without any configs/certs. You can use the following commands for the same. [CLI config...

You can check the following logs from DNAC CLI. You will need to access the maglev cli at port 2222 onboarding-service connection-manager-service network-orchestration-service apic-em-inventory-manager-service      

the time to stop the lan automation is when the device is added to the inventory.the device should be managed and reachable. once you stop the LAN automation, the links will be successfully configured.if you stop the LAN auto before device is added t...

If you want to use a different VLAN for management, instead of VLAN 1.It could be any VLAN number. You can use VLAN 15 as an example.To accomplish this the “pnp startup-vlan 15”This command should be added in the upstream switch to cause the pnp agen...