david-schroeder_2

david-schroeder_2 · 12-12-2003

Thanks for the link. It appears based upon this info that within the 3550, there is no way to see al...

david-schroeder_2 · 12-12-2003

I have a 3550 switch and I am wanting to look at the IP flows much like you can do on a router with ...

david-schroeder_2 · 12-12-2003

As it turned out, their appliance was for satellite links. Their documentation does not state this b...

david-schroeder_2 · 12-12-2003

The vendors documentation said nothing about this being for satellite links but that is what the app...

david-schroeder_2 · 12-12-2003

The vendors documentation did not state anything about there solution being for satellite communicat...

david-schroeder_2 · 12-09-2003

We have an outside vendor touting an appliance that will increase throughput on WAN links substantia...

david-schroeder_2 · 06-30-2003

If you have the proper IOS you can use the IP route-cache flow statement on the interface and then i...

david-schroeder_2 · 06-30-2003

Thanks for the quick response. I did check a couple of routers in question and they were not set to ...

david-schroeder_2 · 06-30-2003

Every so often I have 2600 series routers that loose both the running config and the startup config....

david-schroeder_2 · 06-20-2003

Scott,Thanks for you feedback.Dave

david-schroeder_2 · 06-20-2003

I have a frame circuit that has a CIR of 256 and an access-rate of 512. The telco has physically pro...

david-schroeder_2 · 03-03-2003

Jim,Thanks for your input. I am trying to summarize OSPF areas only at the ABR. I'm trying to reduce...

david-schroeder_2 · 02-27-2003

If you provide Cisco with the serial number and Part number as shown on your output of the show diag...

david-schroeder_2 · 02-27-2003

Don't rule out a circuit issue even though the service provider has said things are good. Can the se...

david-schroeder_2 · 02-25-2003

Take a look at this link for information on the effects of the ip classless command. http://www.cisc...

Re: 3550 Switch