We have been using PNP for a while now. We have had some issues, but we have been slowly figuring them out one by one and giving feedback when possible. However, recently I have been running into an issue where my deployments can get to the controlle...
A coworker of mine and I found out the hard way that if you zoom out your browser, tested in Chrome and Firefox, within a PNP project, all your rules disappear. Zooming in is fine, but if you zoom out , this is when you see the problem. I'm just bein...
Since the addition of templates and configurations as separate entities, we have been using templates to hold our general templates for a certain switch model. This includes our full standard deployment config with variables for vlan differences. Con...
Currently, we are using the dhcp method for pnp discovery. This has been working well, however, our current deployments depend on having 2 uplinks to our upstream switch. On the uplink switch, we use the first link as a trunk and pass specific vlans ...
Still exploring this issue with Peng and in a TAC case. We are theorizing that it is an issue with how the 3 tier cert chain that we installed on our controller is validated on the switch during the PNP process.
Adam, I did see this in the other thread, but I feel so dumb now because I was trying, literally, int range gi 1/0/1 - 48 ($comma = ',') gi 2/0/1 - 48. Now I'm just laughing at myself for not getting that I was actually supposed to make a variable fo...
Here is the log:Dropbox - pnp-service.logAnd here is the pnp tech support:https://www.dropbox.com/s/134tjhf360i7ry3/sh-pnp-tech-support-3-22-17.log?dl=0
Yes, this example is a 2 member stack, however I have tried this with a single member stack and had the same result.With that box unchecked, I get the same result. In the logs, the failed health check fails in the same place, right after the cert get...
