dragos.stroescu

Tamer,The things are not so complicate. First you'll have to test each failure scenario at the remot...

Hello there,We got some pretty much experience in VoIP over FR as we have implemented more than one ...

Yes you can.Use on the respective Loopback interface the commnad:CCM-EXPRESS(config-if)#h323-gateway...

Have you also installed DSP's into the router? If not you will not be able to process VOICE calls bu...

Hello,You must use the hunting mechanism built into the CISCO routers.First you construct two dial p...

Hello,Basically you cannot use two G729 calls on ATA. It seems that there is a DSP limitations and n...

Preferences on dial peers are evaluated on outgoing call legs. For POTS dial-peers, the dial-peer hu...

Hello all,I am facing some very strange problems related to FAX calls on some AS5400HPX used with a ...

Hello,You got a slight improvment by using the newer versions of translations by using "voice transl...

Well it looks we are on the same side of the problem at least! We were not able to isolate it in our...

I am very interested to know if anyone has made an installation of a CIC platform in conjuction with...

Thanks for your update.We've escalated the problem to TAC and also no solution was found.It looks th...

Looks like the issue was identified into the SP area on the respective PVC.Thanks

Serial1/1:0 is up, line protocol is up Hardware is DSCC4 Serial Internet address is 172.16.27.1/30 M...