Is it possible to deploy/manage a spineless VXLAN/EVPN fabric with DCNM using pre-built templates? Everything that I've read or seen in the configuration guide points to no.
When doing a fabric discovery on an ACI fabric with QSFP only leaf nodes, is QSA with 10Gbps SFP+ the only supported way to connect the APIC fabric interfaces to the 40Gbps leaf nodes? Is there any backdoor way to enable breakout support on any inter...
After doing some research, it appears that the most recent version of ACI (4.0(2c)) supports Hyper-V 2012 and 2016. I'm working with a customer who is hoping to upgrading their Hyper-V environment to Hyper-V 2019. Is there any targeted dates or code ...
I'm assuming not, but wondering if ACI Multipod supports overlapping Node Ids between Pods? For example -
Pod1:
Spine01 Node Id = 101
Spine02 Node Id = 102
Pod2:
Spine01 Node Id = 101
Spine02 Node Id = 102
There would be two vPC domains. One in Site A and one in Site B. You can connect two vPC Domains together using a vPC. This is often referred to as a double sided vPC. See the post here - https://www.cisco.com/c/en/us/support/docs/switches/nexus-7000...
What are you supposed to do in the instance of NXOS to ACI conversion? This commonly happens during this process. You could do the conversion with an image a couple maintenance releases back from the fabric version, then do an upgrade via APIC post c...
Thanks for the reply Claudia!. QSAs are supported on the leaf and have been ordered, but I was trying to find a work around to keep things moving. Thanks again for your response.
Is this spine in pod-2 or a pod other than 1? If so, can you ping the 1022 VTEP address (lo0) when sourcing from the VTEP address (lo0) of a spine in pod-1? This the network between spine 1022 and the IPN device defined in the fabric external routing...
Tasks for the ACI MSO were added in ansible 2.8, which was recently released - Link to Ansible documentation for MSO schema module It does require MSO v2.1 or newer.
