Hi,I'd like to setup an HSRP architecture between 2 6500 (MSFC2) and 1 4503 (Sup2 plus TS).The Idea is to use 2 HSRP Groups for each VLAN. (I will have 2 gateways for each VLAN)But I would like to know how many groups I can use on the 4503?I found th...
Hi,I have a design question regarding IPSEC VPN redundancy.I'm using 2 pix515 (6.3.5) on the central site (with 1 ISP for each) and 1 ASA 5510 (7.2.4) on the remote site (1 ISP).The remote site establishes the tunnel to the main site on PIX1. If the ...
Hi,I have a 1841 router with Ifirewall IOS behind a public IP.On the remote side I have a 1801 which is behind a modem/router (with dynamic public IP).... therefore it has a private adress on its outside interface.Central Router (Pub IP)---- Internet...
Hi,I have a 1841 router with Ifirewall IOS behind a public IP.On the remote side I have a 1801 which is behind a modem/router.... therefore it has a private adress on its outside interface.Central Router (Pub IP)---- Internet ---- (Pub IP)Modem/route...
Hello,Everything is in the title...Is it possible to filter/control the internal access of VPN clients that connect to the PIX running PIX v6?How to?regards,
I use just one Crypto Map...crypto map CRYPTO_MAP 20 match address ACL_CRYPTOcrypto map CRYPTO_MAP 20 set peer Pub_IP_1 Pub_IP_2crypto map CRYPTO_MAP 20 set transform-set ESP-3DES-MD5I assume it use the IP in the order.... maybe I am wrong....
Hi Daniel,Does it make sense to use Easy VPN if the remote site has a private IP address?I also have à look at DMVPN but I only have 2 sites... so it takes a lot of configuration for that ;)Thanks