Hello All, I recently moved to a more rural area and have to utilize LTE cellular as my primary internet connection. I have 2 accounts with 1 being in my Cisco C819G LTE router and the other is a Netcomm IFWA-40 that I also use for voice service....
Hello,
I'm hoping someone can help with a strange problem I'm having. It seems like a routing and/or NAT problem, but I'm not sure what is causing it. I just setup a new network in my home this week with a new Cisco ASA 5506-X and Catalyst 3650 24-...
So I think I may have bricked my C819G after trying to upgrade it to a new IOS via TFTP. Has anyone seen this happen before?
I decided I would start with a fresh config and flash while upgrading to the 157-3.M2 image so I used the “erase nvram:” co...
I did a quick Google search but couldn't really find anything with the terms I searched for, but maybe someone here knows how. Is there any way to access the ASDM from a different subinterface/vlan?
For example my ASA is connected internally to an ...
Hey All,
I'm trying to setup a new home network with some new gear I got that consist of a Cisco C819 ISR, ASA 5506-X and 3650 switch. I had no problems with the C819 or the ASA 5506-X, but I can't seem to ping anything other than VLAN10, which ...
Yes this works! Thanks so much for testing and posting it! I set it up for only VLAN20 for now, but the public IP is changing so it is definitely using the outside2 interface like it should as shown in the attached images.On a side note, any idea if ...
I tried your suggestion and a series of permit and deny ACLs as down below, but neither seemed to function correctly.route-map WAN2 permit 10
match ip address VLAN_20_PERMIT VLAN_10_DENY VLAN_30_DENY VLAN_40_DENY VLAN_50_DENY VLAN_60_DENY VLAN_1170_...
well I reset everything back the way it was except with only VLAN20 this time. I read through the PBR guide you linked earlier. It looks like it should be working, but as far as I can tell its not.I have:access-list VLAN_20 standard permit 10.20.1.0 ...