About mariangcisco

mariangcisco · 05-15-2005

Hi,I connected MDS9506 at 2.0.2b level with Brocade in BladeCenter at 4.2.1 level. VSAN on MDS is in interoperability 3 and the only change on Brocade was "portcfgislmode 0/0 1". Then zones, zonesets, IVR info, everything was propagated to Brocade an...

mariangcisco · 04-15-2005

Hi, I just started to work with device-alias and have a question - how do I change a device alias. All I found was "no deviace-alias name..." and then again "device-alias name...". Then commit of course.BUT, pwwns in zones (which were defined using d...

mariangcisco · 03-31-2005

switch(config)# switchname A_AInvalid switchname. Must start with a letter, end with alphanumericand contain alphanumeric and hyphen onlyswitch(config)# switchname A-AA-A(config)#is it a bug or "_" became unsupported ? It is 2.0.2b firmware on 9506I ...

mariangcisco · 03-27-2005

HI, I will have three MDS switches connected together in triangle, using portchannel (2-4 links in portchannel) to connect them. There will be 3 or 4 VSANs. I have to connect Brocade switch to one of them and allow servers connected to Brocade to acc...

mariangcisco · 03-24-2005

I read config guide but don't get clear answer - if I have one VSAN with FICON enabled, one VSAN for storage-server FC traffic and one VSAN for PPRC between IBM ESS 800s and I have portchannel consisting from several links, can I share this portchann...

mariangcisco · 04-20-2005

Two HBAs :) I had three HBAs swapped in triangle and six other wrong HBAs.I cannot find any command to do it, I think it is possible with fcalias, but I had to use device alias as IVR doesn't support fcaliases.BTW I haven't found device alias definit...

mariangcisco · 04-19-2005

No help here ?

mariangcisco · 04-05-2005

And which interop mode would you advise 1 or 2 ? And is it necessary to set interop mode on brocade too ?

mariangcisco · 04-05-2005

I looked at this document and have another question. There is a section specificaly talking about connecting to IBM Bladecenter which is my case. It is stated there, interoperability mode is not needed, but they talk about QLogic switch inside Bladec...

mariangcisco · 04-04-2005

I looked at this document and have another question. There is a section specificaly talking about connecting to IBM Bladecenter which is my case. It is stated there, interoperability mode is not needed, but they talk about QLogic switch inside Bladec...

Member Since	‎10-28-2004 03:28 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	44

User Statistics

User Activity

MDS with Brocade in BladeCenter

device-alias change

unable to set switch name

Cisco with other vendor switch

FICON question

Re: device-alias change

Re: device-alias change

Re: Cisco with other vendor switch

Re: Cisco with other vendor switch

Re: Cisco with other vendor switch