Hi,Great idea, But can I reduce the number of edge switches using VPCS?

Hi,My question is that can I reduce the number of edge switches ? Regards

Hi,kindly give the options if i give 7k and the same for 5k? My question is that whether I can reduc...

Hi,We have two catalyst 6506 switches with 10 gb u plinks and around 120 edge switches cat 3750-x sw...

Dear Reza,Thank you very much for your explanations. So I am planning to buy 30 10G network modules ...

hi,Thanks a lot for the reply.Since 10gnetwork module comes with 4 sfps(one LR AND LRMcan be used fo...

Hi,our network is spread over 15 floors and each floor we have 5-6 switches. we are planning to purc...

Hi, Thanks a lot.Regards

Hi,I am really sorry. Regards

Hi, Thanks for the reply. What about ios ? Cisco says ios should be 12.2 SXH2 or later ?Our ios is 1...

Hi,We have a core switch with the following ios and supervisor engine. Can we add a16 port LR (x2)or...

Hi Reza,How many uplinks (1 gb and 10gb) are avilable for catalyst 3750-x-24ps? I mean built in ? We...

Hi,Can a 10 gb sfp and 1 gb sfp can co- exist ? So the the primary up-link can be 10 gb and and seco...

if 10 gb sfps are used can I use LR and LRM modules? What should be the corresponding ones in the co...

Thanks for the reply. Can I use the existing connectors (sfp) single mode /dual mode in the new swit...