Daniel Davidson
Level 1
Level 1
Member since ‎06-10-2010
‎01-22-2021

User Statistics

  • 52 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
20 Replies
10 Replies
5 Replies

User Activity

I have a private network, and I need to let one IP in that private network map to an IP on the public network.  for example 172.16.1.10 needs behave like IP A.B.C.D on the public network.Normally, I would just add an interface on the system that was ...
We needed to change the IP of our many to one nat earlier today.  Relevant config lines below:   interface Vlan90 ip address 192.168.122.1 255.255.255.0 ip nat inside!interface Vlan281 ip address a.b.c.d 255.255.252.0 ip nat outside ip flow monitor c...
I have a weird issue that I need assistance with.  We have a 6807 that we have been using to make a many to one NAT for our classroom.  Relevant information included below:   interface Vlan90 ip address 192.168.122.1 255.255.255.0 ip nat inside! inte...
We have cisco 3850 stacks on our access layer.  If someone transfers a large amount of data through one, after some time all of that data starts to get broadcast to all ports on the switch, causing all active ports to report that they are running at ...
We have a new 6807 that we are looking to install, but before we do, I need to set up a nat between two vlans.  This is in place and working, but it is extremely slow (about 200KB/s) and we need to get that sorted out before we move forward.  Nether ...
Community Statistics
Member Since ‎06-10-2010 02:06 PM
Date Last Visited ‎01-22-2021 12:42 PM
Posts 52