About chrisgerke

chrisgerke · 04-06-2014

Previously had an ssid configure as follows;dot11 ssid MYSSID vlan MYVLAN authentication open guest-mode!interface Dot11Radio0 ssid MYSSID !But I want to replace it with this;dot11 ssid MYSSID-NEW vlan MYVLAN authentication open authent...

chrisgerke · 01-23-2014

Wondering if someone can share some knowledge, its the first time I've had to do this with a cisco router. I need to forward specific ports to the internal ip 192.168.1.2;UDP 15001-15200TCP 15001I have a standard ADSL model set to bridged mode, a Cis...

chrisgerke · 01-20-2014

Just in the process of updating documentation and I need to let some vendors know a local subnet has changed.We previously had 161.230.247.0 255.255.255.192 but have since changed the mask to 255.255.254.0Would I tell them its 161.230.246.0/23 or 161...

chrisgerke · 01-12-2014

I am trying to create an ipsec vpn to Amazon VPC for the first time but I can't get it to work. Debug crypto isaksmp shows the following;*Jan 13 05:17:52.915: ISAKMP:(0):No pre-shared key with x.x.x.x*Jan 13 05:17:52.915: ISAKMP:(0):Preshared authent...

chrisgerke · 01-05-2014

These are the commands I run to copy into my disaster recovery planning documents. Just wondering if there are any other commands I should run or if maybe this is just overkill.SW 3750 STACKsh versh bootsh env allsh invsh switch detailsh cdp neish vl...

chrisgerke · 04-07-2014

Doh, it was the asa upstream. The aaa authentication match was removed and all is good.

chrisgerke · 04-06-2014

I did, I basically ran a script like this: no dot11 ssid MYSSIDinterface Dot11Radio0 no ssid MYSSID !dot11 ssid MYSSID-NEW vlan MYVLAN authentication open authentication key-management wpa guest-mode wpa-psk ascii 0 MYPASSWORD!interface Do...

chrisgerke · 01-20-2014

Thanks, I forgot about converting out to binary.

chrisgerke · 01-20-2014

Thanks."if you wrote out 161.230.247.x in binary"That's what I was looking for. I've re-read the cisco documentation now and it makes sense. Write it out in binary to get the network.

chrisgerke · 01-20-2014

Thanks, your last paragraph is the bit I'm trying to understand.Because the mask makes the range extend across 246 and 247 why is it that the "network" is 246? Because its the numerically lowest in the range?

Member Since	‎11-24-2011 06:24 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	40

User Statistics

User Activity

Wireless ssid change

Port forwarding cisco 1800 with pppoe

/23 network

Cisco 1800 VPN

DR planning + config backups

Doh, it was the asa upstream.

I did, I basically ran a

/23 network

/23 network

/23 network