nmanicka
Cisco Employee
Cisco Employee
Member since ‎02-21-2018
‎06-05-2020

User Statistics

  • 33 Posts
  • 2 Solutions
  • 5 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
10 Replies
5 Replies
1 Helpful Vote
1 Accepted Solution

User Activity

Symptoms With EFM 1.7 release, some previous warnings are now treated as errors, hence ParStream does not start via Systemctl Diagnosis Check the /var/log/parstream/server-xxxx.log file You might see errors like:   ERROR-77082: Number of maximum f...
Q. Where can I find the Cisco Kinetic DemoKit Setup Guide? A. Refer to the "Cisco Kinetic Demo Kit Guide" on Salesconnect (https://salesconnect.cisco.com/#/program/PAGE-10238 then under the "Demo Kit" tab)   Q. Where can I get support for the DemoKi...
EFM v1.6.1 IOx application now supports passing parameters via GMM. This capability now enables configuring an upstream broker for that EFM node via GMM UI.   Step 1: Install EFM 1.6.1 IOx app within GMM Step 2: Deploy this app on a gateway (The upst...
  There are a couple of ways to connect EFM with DCM: DCM DSLinkUsing MQTT DSLink The MQTT method is outlined here. Install and start MQTT DSLink on EFM node         From dataflow editor page: Configure the MQTT link to connect to DCM   name<Any ...
Why do we need Edge Data Processing?     EFM is based on open source DSA Project DSA Architecture       Broker Highlights   * Transparent multi-hop routing between message brokers* Reliable and flexible data delivery between nodes* Runs at the edg...
Community Statistics
Member Since ‎02-21-2018 01:28 PM
Date Last Visited ‎06-05-2020 11:18 AM
Posts 33
Total Helpful Votes Received 5
Helpful Votes From
Helpful Votes Given To