Greetings,I have a configuration issue with an Aironet 1262N running in Autonomous mode. It is connected to a dot1q trunk port on a 3750G (POE version). I have attempted to configure a suite of SSIDs but only one SSID seems to be available - "tbmx"....
Hi community, I am setting up a "new" configuration of a 3750G 24PS and 3750 48PS.There are various vlans which I have yet to use because I can seem to get DHCP to work.The configuration is setup to lockdown the inter vlan comms once the basics are w...
Hi all, I am having issues setting up a few Aironet 1262s (AIR-LAP1262N-E-K9) They are powered from a 3560 PoE-8 (only one at a time) and they power up...The power comes on and the light flashes green for bit (I assume booting)The light then is yello...
Hello Cisco community, I have an odd and seemingly frustrating problem...I have a set of switches/devices - Catalyst 3750 an 2960 plus a RV325The RV325 is the gateway to the internet using the primary ISPThere is a second ISP which is there for inter...
Hi
I have a 3750 and 2960 with dhcp, vlans and trunking - everything works - many thanks to Rick.
I need to prevent traffic from going between certain vlans, and some vlans can be the source into others but not be destinations:
Let's take the fol...
Hey BB! Many thanks for the comment and suggestion - which lead me to the solution: I don't believe that it was "interface definition" but you did only say that you examined the config at a high level - so fair enough. However, the good document you ...
Hi Rick,I finally found the time to complete this project and your advice was invaluable and the answer to question.(I also removed the trunk connection and instead used a stack master/slave arrangement)I had one question regarding default route:when...
Hi Paul, Rick and others,I have accepted both your solutions because both were issues (and more too):Paul's default route worked (also was Rick's comment too)Rick's comments on the password setup were also very validMostly Rick's comment to check tha...
Hi Rick,I see what you did and I believe that it is most likely going to be the solution.One of the reasons for my delay is that I needed to put in a new POE switch so thought that I would incorporate your changes in this little upgrade - which is no...
hi Rick, Many apologies for the gap between your question and this response: "Modem 2" on the diagram will provide NAT and knows to route vlan3 traffic back via vlan2/vlan3 gateway. Do you have any suggestions regarding commands to configure the 3750...