Hi All... I have to implement 6 of Cisco NCS 4202 devices connecting into 2 Rings topology. I need help advising on the design and feature that is best for the topology like this. Please see the attachment for the network diagram. There are 3 locati...
Hi! I am running UCCX SSO test in my lab. I have got to the point where I need to click Test SSO and if everything looks good then I should be able to enable SSO after the Test. However, after I ran the SSO Test [accepted certificates, logged in with...
Hi All,
I am trying to enable OBTP feature on Webexboard 55, but not successful yet. Can anyone guide me on this? I have read the Webexboard 55 datasheet and it said it support OBTP feature with cloud registered which is matching in my case. Still ...
Hi All,
Anyone have any idea on how to back up TMS system with CMS system added?
I tried "In Cisco TMS: Systems > Configuration Backup > Perform Backup"but CMS system is greyed out and said not support
Thank you very much..
Hi All,
I am connecting 2 pair of NEXUS 9500 using vPC DCI with HSRP. I can't seem to find the detail in any document on how to set this exactly. Right now, I am a bit confusing on the VLAN priority that should be set on each pair of nexus switch. ...
Thank you Jonathan Schulenberg for replying my question.
I just got confirmation from Cisco support as well that this OBTP feature for webex board is under delveloping and to be released soon.
Regards,
Prachaya K
I just found this information on TMS backup
https://supportforums.cisco.com/t5/telepresence/tms-disaster-recovery/m-p/2230410#M20695
Is this the correct way to do back and restore of TMS system? By backing up only SQL database
Prachaya K
Hi Wayne,
Thanks for your reply. The version of TMS is 15.6 and CMS is 2.2.8
How about backing up the configuration that have been configured on TMS system itself? So once the TMS system went wrong, then I could just simply restore the configurat...
Hi Rick1776
I'm not sure what you mean. Both side are the same as you can see from below:
This is interface po98 on NX-1:
interface port-channel98 switchport mode trunk switchport trunk allowed vlan 482-483,910-939,960-979 spanning-tree port t...
