About rasmus.elmholt

rasmus.elmholt · 02-13-2024

Hi everyone, Can some one tell me or point me in the right direction on how to configure and verify if ICMP type 3 & 11 are allowed in a fortigate firewall, to make sure ThousandEyes are showing the correct path visualization? I want to make sure tha...

rasmus.elmholt · 02-05-2024

I have made some simple templates that should configure dot1x on userdefined ports. But when I try to provision the template, either to the device or just to preview I get an #Conflict error in the CLI output. Running DNAC 2.3.5.5 on Cat9300 on IOS 1...

rasmus.elmholt · 11-21-2023

Hi all, I have by mistake tried to install version 17.06.05 on a 9300LM switch with the result that it is not able to bootup. I have now tried to make a recovery using USB and FTP but none of it works. The strange part is that whenever I try to boot ...

rasmus.elmholt · 10-10-2023

Hi, I have a issue with a vendor where they say there are packet drops between some of their devices and a server. I have 5 Cameras streaming uncompressed packets to a server at 500mbit/s each. I cannot see any QoS drops or interface errors on the in...

rasmus.elmholt · 08-29-2023

I have a DNA center with Version 2.3.5.3-70194. But the serial number is not available in the GUI, it just shows Default String. At the same time I am unable to log in to the CIMC. It logs me in but gives an error as shown here: Any suggestions w...

rasmus.elmholt · 03-20-2024

Hi @dontsellmydata Have you ever found a solution to this problem, with starting the pnp agent after the stackwise virtual is configured and up and running?

rasmus.elmholt · 03-14-2024

Hi @mhiyoshi Did you ever find a solution for this? I have a setup as well, where we are running eBGP on the secondary address of a link, and I cannot get BFD up.

rasmus.elmholt · 02-20-2024

We changed one of the tests to run path trace mode: in-session and the user-agent to something other than the default. That solved some of the issues. The funny thing about this was that an traceroute using TCP-SYN port 443 was shown correctly when d...

rasmus.elmholt · 02-16-2024

During my troubleshooting I found some log in the apic-em-network-programmer mentioning a conflict. But when I try to find the right Template it does not exist. Log: 2024-02-16 12:21:58,425 | INFO | http-nio-17125-exec-1 | | c.c.a.t.p.s.u.Te...

rasmus.elmholt · 02-12-2024

I have used this tool developed and maintained by some Cisco guys for a while: https://github.com/cskoglun/ciscodnacbackupctl

Member Since	‎12-23-2015 09:22 AM
Date Last Visited	‎04-19-2024 12:05 AM
Posts	679
Total Helpful Votes Received	432

User Statistics

User Activity

Allow ICMP types on Fortigate

Template config

Unable to recover a 9300LM switch

Packet drops on stack port?

Issues with the CIMC and S/N information

Re: Plug and play of 2x9500 in VSL

Re: Catalyst9300 BGP peering with secondary IP and BFD

Re: Allow ICMP types on Fortigate

Re: Template config

Re: DNA Centre Backups