samsam_wang

two questionsFirst,What is the diffirence between them?one is in global configuration mode, another ...

Wrong resultthe IP of R3' Loopback0 is 192.168.3.3/24on R1, I set a static route point to R4,likeip ...

Thanks againI got all information.for multi-path, the prefer order islongest match---intra area----i...

I will confirm that.if the 64K link is ISDN, when I ping EIGRP from R1, the ISDN will up and flappin...

Great.I need to confirm that.if EIGRP is still between R2 and R3, so all traffic will go via 64K lin...

Thanks for your answer.I don't understandR1 has two paths to ASBR, both of them via intra-area (area...

see my topologyR1--64K ospf area2---R2---EIGRP---R3R1--10M ospf area3---R4---10M area3--R5--10M area...

Thanks.I am still confused.Lower SPF with higher cost is the better path than higher SPF with lower ...

In OSPF or ISIS, When I "show ip ospf border-router"there is SPF value at the end of each line. anyb...

Hi, Ruwhite It seems that you read and understood all articles on cisco.com and you know everything....

Yes, you can do aux back-to-back.for the RJ11 cable, I guess it doesn't work, I never tried it befor...

three ways1, shut down your main serial interface, NOTE, not sub-interface2, change the encapsulatio...

R3interface Serial0 ip address 192.168.0.3 255.255.255.192 encapsulation frame-relay ip ospf priorit...

TopologyR1 s0.1--area0----s0 R2R1 s0.1--area0----s0 R3 same subnet, 192.168.0.0/26R3 s1---isis---s3 ...

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/index.htm