About dcooke

dcooke · 01-15-2015

Dear All I haven't found the above combination to be particularly well documented by Cisco (and there appears to be no documentation on ASA and the VNMC replacement Prime Network Services controller). Anyhow we have struggled through! The last hurdl...

dcooke · 08-06-2009

I have just upgraded from ASA (with AIP-SSM base license) version 7.2 to version 8.2. All of the Gigabit interfaces in 7.2 were reset to 100 meg in 8.2 and it is not now possible to set them to Gigabit.I have rolled the ASA back to 7.2 and it can now...

dcooke · 06-19-2008

Hi GuysCouldn't find any answer to this anywhere so hope someone can help.We are trying to connect our 877 DSL router to Verizon DSL. Of course they are no help at all as once you tell them you are using a Cisco router you may as well admit to having...

dcooke · 11-05-2007

Hi all. This will no doubt be very simple for someone - but I am quite new to this!Essentially we have a server (server1) plugged into a C2950 - port 2. It has several addresses on one physical adapter. These are in different networks eg. 192.168.6.2...

dcooke · 10-30-2007

Forgive me if someone has asked this before - though I couldn't see anything relevant on a forum search.I have CSS box-to-box redundancy working fine. The servers we are load balancing have x2 adapters which are teamed with a cable to each CSS.If one...

dcooke · 08-10-2009

Cisco are currently saying this is a bug! Gigabit wasn't supposed to be available in 7.2(3) base license - but it was. This "issue" was fixed in release 8.0(4) - (CSCsl53995 - 5510 interface can be set to 1000Mbps with base license).Crazy. So the upg...

dcooke · 06-20-2008

Thanks p.bevilacqua . That sorted it! Still am confused though!1) I thought IOS had routing turned on by default?2) If it was needed why didn't the SDM turn it on?3) If there is a default gateway I didn't think ip routing was needed?Anyway, thanks ve...

dcooke · 06-20-2008

I rebuilt the NAT on VLAN1. The entire config is below. Still no translations taking place from inside to outside.Where can I go from here? May have to admit defeat and raise a TAC!!version 12.4no service padservice timestamps debug datetime msecserv...

dcooke · 06-20-2008

Yes it looks like it isn't translating anything.The sh ip nat translations list is blank (no entries) and the sh ip nat statistics is all zeros.I'll try and recreate the nat and see if it does anything.

dcooke · 06-19-2008

Thanks - I think I just lost a whole post so hopefully this isn't a repeat.Yes, it looks likely to be a problem behind the router. I can ping the gateway (yes that is the xxxx in the route). I can also ping outside the gateway. I can also ping the AT...

Member Since	‎11-22-2004 03:28 AM
Date Last Visited	‎08-24-2018 02:02 AM
Posts	30

User Statistics

User Activity

Nexus 1000v and ASA 1000v

ASA upgrade disables Gigabit

877 - DSL config

Multiple Vlan addresses on adapter problem

CSS - adapter teaming with box-to-box redundancy

Re: ASA upgrade disables Gigabit

Re: 877 - DSL config

Re: 877 - DSL config

Re: 877 - DSL config

Re: 877 - DSL config