jmcgrady1
Level 1
Level 1
Member since ‎06-10-2018
‎03-20-2024

User Statistics

  • 103 Posts
  • 0 Solutions
  • 25 Helpful votes Given
  • 35 Helpful votes Received
Recent Badges
50 Replies
 30 Helpful Vote
10 Helpful Vote
20 Replies
1 Helpful Vote
10 Replies
5 Replies

User Activity

On a C9300 switch, is there a limit to how many interfaces can be spanned to one port? For example, say i had a layer 3 network of 10 switches all spanning to a single port on one C9300 - is there a practical limit?
When starting the WLAN wizard on a 9800 controller, the type 'local mode' includes Dot1x auth. But the type 'flex connect' does not. The environment i am migrating from includes a WLAN which uses dot1x for auth and flex connect to have each AP use a ...
I'm applying QoS to a 100mb ethernet link on a Cisco 4431 router.   Say i have a priority queue (realtime) set to use 10% of available bandwidth; then a critical apps queue set to 30% of remaining bandwidth; then other queues spit up the remaining. R...
What would be your recommended Cisco model to provide 4 x 10gb ethernet routed interfaces?  Support for EIGRP, BGP, and QoS is needed. The less SDWAN functionality the better. Dual PSU is also needed.
I have a 2 link portchannel between a clustered pair of c9500 and a c3850.  The config is simple enough, each end has the aggregate interface defined: interface Port-Channel1switchport mode trunk Member interfaces are defined like: interface TenGigab...
Community Statistics
Member Since ‎06-10-2018 10:05 PM
Date Last Visited ‎03-20-2024 12:30 AM
Posts 103
Total Helpful Votes Received 35
Helpful Votes From
Helpful Votes Given To