Hi,I have to send my configuration via snmp by uploading the tftp to the router. I have no problem with ACL where I just send the different acls written in a file, also no problem with the configuration of the different Interfaces, but it does not wo...

Hi,I have a 800Series Router to configure. When I try to configure the FastEthernet0-4 ports by giving them an IP address (manually or via dhcp), I have the following error :IP addresses may not be configured on L2 links As far as I can understand, t...

Hi,Is it possible to change the default tftp port on which a router is listening, i.e from 69 to 4002 for example ?ThanksChris

Hi,I have to work with a Cisco 800 Series and give some routing parameters to each Interface. I was reading the following page on static routing : http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800c...

Hi,When a packet is denied because of a rule in the ACL, is it actually possible to specify the ICMP type and code that will be used to inform the sender ?ThanksChris