Hi Ray,I may ask a silly question..To what port in the modem are connecting your router? Also can yo...

Also you can use tha passive interface command in rip to restrict the hub from sending updates.

I would like to add a small question if I may...actually 2Does the DHCP server "knows" where you are...

You can configure on the servers more than one gateway. Have router 2 ip configured on the servers a...

Have you tried just for testing, to give vlan 1 on router an IP address on same subnet and try to te...

Does your Symantec Gateway has a route back to 172.16.1.0 network? Hope this helpsEugen

First check the AP power needs and the max it support. Don't want to "fry" it.You may need to config...

You default gateway on PC is the firewall at 10.0.0.1 since it gives the DHCP address, I assume. I w...

You need to apply the policy map to fastethernet interfaceip policy route-map nonatHope this helpsEu...

Check your PCs if they get a default gateway. In your DHCP pool configuration you are missing the de...

Hi Alex, did you try to create a user with privilege 0 or 1, that is what most literature on cisco r...

Have a look thru this, it may helphttp://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software...

Did you try to change the network statement in eigrp to include other subnets too? router eigrp 10ne...