Hi All,
what about inspection,suppose we made two policy and apply on the same interface .
Q.A)one of two policy will work?
access-list 101 permit ip host 1.1.1.1 host 2.2.2.2
class-map drop_class
match access-list 101
policy-map drop_policy
clas...
Dear All,
Kindly suggest (A)
I configured Active (ASA1) and Standby(ASA2) failover, both are working fine .
Q.....When I shut the ASA1 and when it will come in ok position must be active. Kindly suggest ,is it posible or not .if yes, suggest comm...
Dear All,
Kindly suggest,CPU utilization is showing 55.95% for Cat4k Mgmt LoPri .
what is Cat4k Mgmt LoPri ?
Show process cpu
CPU utilization for five seconds: 68%/2%; one minute: 64%; five minutes: 61%
PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Mi...
Hi ..
Please suggest me for below lines .In which topology we have to use these commnads separately and individually .
ip verify reverse-path interface outsideip verify reverse-path interface insideip verify reverse-path interface DMZ
Regards
Arsh...
Hello ,
I am facing problem of flapping at Switch 4510R, Please suggest
as i looked in some example:-all discribed that need to discount of both port one by one .....
i can't do this because my network is very critical ,if no other option then i w...
Hi Akshay ,
above link is very usefull for me .....
I got some configuration retaled to this, your suggstion is also very perfect for me .
Thanks you very much
Regards
Arshad Ayub
