Hello,I am getting the following error message on an ASR 9006 router "vlan_ea[396]: %ETHER_EA-3-TCAM_REGION_OOR : Error during TCAM allocation, TCAM Region 3 has ran out of resources"How can I check which TCAM space/region is exhausted and how to che...
Hello, I am trying to bring up an 100G link on Cisco 9364 using 3rd party CWDM4 QSFP28 but the TX power is NA. Can I change something to fix it? I tried to disable fec, to set the speed to 100G but without any luck. The output of show int trans det i...
Hello,I am trying to "tag" with an extcomm a route via a route-policy in network command and I am getting the following error:router bgp 65501address-family ipv4 unicastnetwork 192.168.0.0/24 route-policy TAG_INBOUND(EXT_1, EXT_2, EXT_3)!!% Could not...
Hello,I am trying to enable a Q-in-Q tunnel behind these two Nexus switches (92304Q,9236C) but I cannot reach the other side. I read this document"https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/7-x/interfaces/configuration/gui...
Hello,I am wondering if it is possible to map a vlan (C-VLAN) to an outer VLAN (S-VLAN) based on source MAC address. e.g if the traffic is coming on VLAN 1234 and the source MAC is the 1111.2222.3333, map this traffic to S-VLAN 5. If the traffic is c...
Thanks for the answers. So, Is there any document that describes the partitions usage eg how did you know that the partition 3 is about l2transport interfaces? Is this documented somewhere?
Sorry for the misunderstanding, but i am referring to the scale of the platform. I indeed have 4096 l2transport subinterfaces. So, is this a generic scale limitation or it is only on my platform with A9K-2x100GE-TR LC?
Hello,I already run these commands but I didn't located the region. The output is the following: show prm server tcam summary all all all location 0/0/CPU0
Node: 0/0/CPU0:
-------------------------------------------------------------...
