s.conway

s.conway · 12-27-2005

I have a 4000 at home with 2 4 port serial and 1 2 port ethernet. Using it as a frame switch with no...

s.conway · 09-26-2005

What type of SUP does it have? I think the older SUPs use the standard console cable (roll-over) but...

s.conway · 09-12-2005

Here is a link for setting up modem connections to switch console portshttp://www.cisco.com/en/US/pr...

s.conway · 08-29-2005

This is a strange problem. I did find a bug that comes very close to your problem. It is for 2600XM ...

s.conway · 08-29-2005

Here is the Cisco link for configuring back-to-back serial connections. I have several of these in u...

s.conway · 07-19-2005

I've had issues where the memory has become fragmented severely enough that there wasn't enough free...

s.conway · 05-29-2005

I have a Lynksys wireless 4port Eth connected to a 2509 using a straight through cable. I would thin...

s.conway · 05-08-2005

This is from the error decoder1. %PM_SCP-3-GBIC_BAD: GBIC integrity check on port [dec]/[dec] failed...

s.conway · 05-08-2005

This link has general instructionshttp://www.cisco.com/en/US/customer/tech/tk801/tk36/technologies_c...

s.conway · 04-12-2005

I'm not familiar with that type of modem. I work with externl modems. Sometimes we need to set the S...

s.conway · 04-12-2005

What tftp software are you using? I've used the free one from Solar Wind and I think it defaults to ...

s.conway · 03-15-2005

added the pdf for your review

s.conway · 03-14-2005

found this linkhttp://www.cisco.com/en/US/customer/products/hw/switches/ps700/products_tech_note0918...

s.conway · 03-07-2005

This page shows the 2520 and 2523 having S/T interfacehttp://www.cisco.com/univercd/cc/td/doc/produc...

s.conway · 02-27-2005

boson.com has a config reg tool athttp://www.boson.com/promo/utilities.htmI tried it and it listed t...

Date Registered	‎02-01-2001 01:18 PM
Date Last Visited	‎07-29-2021 07:54 PM
Total Messages Posted	146
Total Helpful Votes Received	16

Re: Cisco 4000 Router