@Reza Sharifi wrote:From the switch, can you ping 172.16.251.6 with source of 172.16.251.50? Also, w...

@Reza Sharifi wrote:interface Vlan251 ip address 172.16.251.50 255.255.255.0Is interface vlan 251 in...

@Reza Sharifi wrote:Can you try this config and test:Basically delete vlan 251 from the trunk port a...

@Reza Sharifi wrote:Looking at the configuration of the new stack. command switchport trunk native v...

Disclaimer: I know a bit about Cisco switches, but I will be the first to admit that there is a LOT ...

I have the tar files as well, so that is a non-issue. But, which tar file do I point to in the archi...

I have a Switch Stack that is mixed between 2960S and 2960X switches. As you can see from the table ...

@Sheraz.Salim by all means, have at it. I've been struggling with this for far too long. The more ey...

@Rob Ingram My apologies for the delayed response. I took a packet capture from the Watchguard devic...

In regards to the Meraki packet capture not showing anything, I decided to try again (this is all ne...

@Rob Ingram @Sheraz.Salim You are correct. That diagram was inaccurate. Thank you for pointing that ...

@Rob Ingram My apologies, the Meraki is 172.16.250.1 and is connected to interface GigabitEthernet0/...

@Rob Ingram Looking at the captures from the Meraki device, they appear to not have all of the data ...

Time to show off my lovely Visio skills, heh.    

@Rob Ingram The remote host in this case is 24.96.28.186