I have an ISR 1000 series router (IOS XE 16.9) connected to 2 PPPoE lines to 2 ISPs. Dialer0 is slower but more steady, Dialer1 is faster but fails every few days (BRAS will fail to authenticate for some minutes). I want to build a failover mechanism...

I'm running IOS XE 16.9.3. I configured the IOS XE as a BGP flowspec client. I can verify the config is working: Server side:gobgp global rib -a ipv4-flowspec add match source 192.168.1.2 then discardClient side:Router#show flowspec afi-all AFI: IPv4...

the ISP routes a single IP to our gateway router. So our gateway router is set up this way: int Gi1 ip address 10.0.0.2 255.255.255.0 int Gi2 ip address 192.168.1.1 255.255.255.0 int Lo0 ip address 1.2.3.4 255.255.255.255 ip route 0.0.0.0 0.0.0...

I have 2 dialer interfaces from 2 ISPs and I want to do a policy based routing setup using a dynamic routing protocol. Is this possible with IOS XE 16.9? route-map seems doesn't allow me to use dialer interface as next-hop, or use the default route i...