Hello all,
I am going to add a new interface to vManage or vBnod which are running in a VM on ESX but by default the interface is down. Since I don't have root permission how can I bring them up?
I really appreciate it if there is a solution.
...
Hello all,
I am trying to add vBond to vManage but I faced some difficulties in this process. Sorry, if my questions are preliminaries:
- Since I need to have two ip addresses one for VPN and one for system-ip, can they be on the same interface?...
Hello all,
I am trying to add NETCONF device to NSO through python API as follows:
import ncs;
with ncs.maapi.single_write_trans('admin', 'python', groups=['ncsadmin']) as t:
root = ncs.maagic.get_root(t)
root.devices.device.create('test')
root.d...
Hello all,
I am newbie to SD-WAN. I have two general questions regarding the SD-WAN:
Does SDWAN can communicate with NETCONF in southbound?
If I have a device described by yang model, can I introduce it to SDWAN?
I really appreciate it if some...
Hello all,
I am a newbie to SD-WAN and vmanage. I am going to add an VM with an VPP as a new device to the vmanage. I was looking a bit at documentation, as much as I understood I should provide a serial configuration number to it. But in my case...
Thanks for the reply. I set the netconf.ned_id to 'netconf' and I removed the netconf.protocol. Still I have the following ERR:
File "src/ncs/pyapi/ncs/maapi.py", line 1005, in applyself.maapi.apply_trans_flags(self.th, keep_open, flags)File "src/n...
Still it does not work. My goal is to add a netconf device do you think my syntax is OK:
root.devices.device['test'].device_type.cli.ned_id = ...
device_type.cli does not indicate I am adding a cli device?
Thanks,