Cisco Community
English
Register
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
allan.thomas
‎03-14-2019
Collaborator
Awards
1
Spotlight Awards Mobile App Contributor November 2012
Recent Badges
Awards
Recent Badges
See all
CCP Member
50 Accepted Solution
15 Accepted Solution
1 Accepted Solution
5 Accepted Solution
100 Helpful Vote
30 Helpful Vote
600 Helpful Vote
300 Helpful Vote
10 Helpful Vote
Stats
Member since ‎10-17-2002
1305
Posts
1147
Helpful
118
Solutions
Certifications
Cisco Certified Network Professional Routing and Switching (CCNP Routing and Switching)
Cisco Certified Network Associate Routing and Switching (CCNA Routing and Switching)

Re: Dial Peer and ISDN map address issue

Created by in Other Collaboration Subjects
08-07-2003
08-07-2003
Have you tried configuring a translation rule, which is specified as a translate-outgoing for the PO...

Re: What phones get connectivity when using SRST 3.0

Created by in Other Collaboration Subjects
08-07-2003
08-07-2003
CallManager 3.3 provides the ability to configure SRST references. Each SRST reference you configure...

Re: Conferencing ,Transcoding and PSTN access on same NM-HDV Car

Created by in Other Collaboration Subjects
08-07-2003
08-07-2003
Inorder to provision DSP resource for either Conferencing or Transcoding, you need to specify which ...

Re: CDR Install

Created by in Other Collaboration Subjects
08-07-2003
08-07-2003
Incidentally, the default userid and password is admin, admin. Once you login into CAR using these c...

Re: CDR Install

Created by in Other Collaboration Subjects
08-06-2003
08-06-2003
Users can only access CAR through a secured login from the Cisco CallManager Serviceability Tools me...

Re: CallManager MGCP support for a 2651 with AIM-VOICE-30 and VW

Created by in Other Collaboration Subjects
08-06-2003
08-06-2003
Support for the 2651 AIM-voice-30 was available in 3.3.2, unfortunately I found that after upgrading...

Re: Transcoding with CM 3.3(2)

Created by in Other Collaboration Subjects
07-31-2003
07-31-2003
As previously mentioned the 6608 is completely independant module. You only need to specify in CatOS...

Re: CallManager MGCP support for a 2651 with AIM-VOICE-30 and VW

Created by in Other Collaboration Subjects
07-30-2003
07-30-2003
Coincidental as it may seem, I have just posted a conversation regarding adding 2651XM-V MGCP Gatewa...

No Slot 0 when adding 2651XM-V MGCP Gateway in CCM 3.3.3

Created by in Other Collaboration Subjects
07-30-2003
07-30-2003
When you specify 26xx from the list of gateways under CCM 3.3.3, there is no slot 0 available in ord...

Re: QoS on 6000

Created by in Other Network Architecture Subjects
10-23-2002
10-23-2002
Reclassification is not required on the ingress port when the port is configured to trust-cos, there...

Cat 6000 Flexwan HSSI Transmit Ring Entries

Created by in Other Collaboration Subjects
10-17-2002
10-17-2002
Through implementing LLQ it is evident that policy maps exhibit traffic falling into the fair-queue,...
Public Statistics
Date Registered ‎10-17-2002 05:01 AM
Date Last Visited ‎03-14-2019 11:42 PM
Total Messages Posted 1,305
Total Helpful Votes Received 1147
Helpful Votes From
Awards
Community Spotlight Award
Mobile App Contributor November 2012